Journalartikel

Role of Excess Bi on the Properties and Performance of BiFeO3 Thin-Film Photocathodes


AutorenlistePrasad, Nitin P.; Rohnke, Marcus; Verheijen, Marcel A.; Sturm, Jacobus M.; Hofmann, Jan P.; Hensen, Emiel J. M.; Bieberle-Hu''tter, Anja

Jahr der Veröffentlichung2023

Seiten12237-12248

ZeitschriftACS Applied Energy Materials

Bandnummer6

Heftnummer24

ISSN2574-0962

Open Access StatusHybrid

DOI Linkhttps://doi.org/10.1021/acsaem.3c01926

VerlagAmerican Chemical Society


Abstract
BiFeO3 (BFO) has recently been identified as a promising photocathode material for photoelectrochemical (PEC) water splitting due to its light absorption and photoelectrochemical properties. The performance-limiting factors, in particular the impact of stoichiometry on the performance, still need to be understood. The effect of the ratio of Bi/Fe in the precursor solution for sol-gel synthesis on the properties and performance of BFO thin films is investigated in this study. Thin films with a stoichiometric Bi/Fe ratio and with a 10% excess of Bi are prepared on fluorine-doped tin-oxide substrates. While bulk characterization techniques show the formation of phase-pure BFO, surface characterization techniques indicate Bi enrichment on the surface. Light absorption and band gap do not change with excess Bi, whereas the current density is two times higher for Bi excess films compared to stoichiometric films at 0.6 V vs RHE. Electrochemical impedance spectroscopy attributes this improved performance of excess Bi thin films to a lower recombination rate and a lower charge transfer resistance. The lower recombination rate is attributed to fewer Bi and O vacancies, which can act as recombination centers. Therefore, adjusting the Bi/Fe ratio is an effective strategy to enhance the PEC performance of BFO photocathodes.



Zitierstile

Harvard-ZitierstilPrasad, N., Rohnke, M., Verheijen, M., Sturm, J., Hofmann, J., Hensen, E., et al. (2023) Role of Excess Bi on the Properties and Performance of BiFeO3 Thin-Film Photocathodes, ACS Applied Energy Materials, 6(24), pp. 12237-12248. https://doi.org/10.1021/acsaem.3c01926

APA-ZitierstilPrasad, N., Rohnke, M., Verheijen, M., Sturm, J., Hofmann, J., Hensen, E., & Bieberle-Hu''tter, A. (2023). Role of Excess Bi on the Properties and Performance of BiFeO3 Thin-Film Photocathodes. ACS Applied Energy Materials. 6(24), 12237-12248. https://doi.org/10.1021/acsaem.3c01926



Schlagwörter


Bi/Fe stoichiometrybismuth ferritebismuthoxideBIVO4 PHOTOANODESHEMATITEPHOTOCURRENTphotoelectrochemical water splittingVACANCIES

Zuletzt aktualisiert 2025-10-06 um 12:01